OPERATION
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Betontrennschneider / Concrete cutter ZI-BTS350
Seite 27
Leave for a few minutes without engine load.
When a load is always at max throttle. Hold speed!
16.1.2
Warm start
Press the ON-OFF switch to the ON position.
Combination switch (2) in the OPEN position on the right. Do not choke on a warm start.
Engine with pull starter start as in 16.1.1
16.1.3
Switch off
For a longer life of your engine you let the engine to idle for 3-5 minutes before turning off
idle.
ON OFF switch to OFF position switch.
NOTE:
The length of the starter pull rope is 1.15 meters. Do not pull with great force. When all the
rope has been pulled, the rope is pulled with further train. In addition, it can also mean that
the parts are damaged.
Once you have pulled the rope, should you let it go immediately. One should continue to hold
the hand lever of the starter pull rope and lead it back down.
The rope should be straight up or down to reduce wear.
After the train of the starter pull cord you can roll it slowly.
At this time, when the gasoline engine is not started successfully, it is necessary to press the
button of the decompression valve again to restart.
16.1.4
Water supply
The water connection, you can connect a water supply.
This allows you to achieve a uniform cooling of the blade and reduce the formation of dust
strongly.
Operation
Review safe working environment, safe work clothing, machine before putting on faultless
and operational condition.
Saw at Max. , align top position, fold down section markers (linkage with red roller) to cut
line. Align the saw blade to cut line.
gate valve at the bottom of the water tank open.
Start the engine 6.2.1
blade wind down slowly deepen the cut until the desired depth of cut is reached.
Cut only as fast as it allows the material. If the blade lifts the feed, you slow down the feed!
If desired cutting depth of more than 90mm, this should be achieved through two steps.
The proper sense of the proper feed speed is important. Please slide the machine fast
enough that the blade can work into the material, but once they realize that the speed de-
creases, reduce the feed.
No lateral pressure on the blade.
Can not operate without blade guard mounted!
Do not force the blade into the material. Let the wheel going into the material alone.
Do not perform long continuous cuts.
