7
Rear Hub Bearing Removal
R e a r H u b B e a r i n g R e m o v a l
Insert a 5 mm hex wrench into the axle while holding the non-drive
side cap nut with a 20 mm hex bit socket and socket wrench. Hold
the socket wrench in place and use the hex wrench to turn the
non-drive side cap nut counter-clockwise to remove it.
Use your fingers to remove the driver body assembly from the hub
shell.
Remove the axle, by hand, from the driver body.
A flat washer rests on the bearing located on the side of the driver
body with the pawls and leaf springs. If this washer falls off when
you remove the axle, set it aside until you are ready for assembly.
Use your finger to remove the bearing shield from the non-drive
side of the hub.
20 mm hex bit
5 mm Hex
1
2
3
4
