18
Rear Hub Bearing Installation
Insert the axle through the driver body.
Make sure the black dust shield is installed on the axle on the
outboard side.
Make sure the driver body seal is seated into the seal groove on
the axle.
Slide the axle and driver body, ratchet side first, into the rear
drive side hub shell.
Use your fingers to compress the pawls to allow the driver body to
fully seat inside the hub shell.
Thread the cap nut onto the non-drive side axle by hand.
Insert a torque wrench with a 5 mm hex bit socket into the drive
side axle while holding the non-drive side cap nut with a 20 mm
hex bit socket and socket wrench. Hold the cone wrench in place
and use the torque wrench to tighten the cap nut to
10 N
·
m (88.5 in-lb).
9
10
11
20 mm hex bit
10 N
·
m (88.5 in-lb)
5 mm hex bit
