14
Driver Body Bearing Installation
Insert the ID spacer tube.
Align the ID spacer tube with the inside race of the previously
installed bearing.
Install a new 6803 bearing into the outboard side of the driver
body.
Slide a Wheels Manufacturing 6803 bearing press tool onto the
threaded rod of the Wheels Manufacturing Press-1 Sealed Bearing
Press tool. Insert the threaded rod of the bearing press through
the outboard side of the driver body. Slide the SRAM 6803 bearing
press tool onto the threaded rod.
Thread the bearing press handle onto the threaded rod.
Turn the threaded handle clockwise to press the bearing into the
outboard bearing bore until it is hand-tight.
Remove the bearing press tool.
N OT I C E
Do not overtighten the bearing.
Applying excessive force while installing the second bearing may
result in damage to one or both bearings.
Use a syringe to apply a small amount of SRAM® Butter into the
pawl pocket
4
ID spacer tube
5
SRAM 6803 Bearing press tool
SRAM 6803 Bearing press tool
6
SRAM® Butter
7
