18
Another view of glassed seam.
Deck formers installed in bulkheads 4 and 5.
Checking deck formers with straightedge.
Trim the building tabs, and sand the bulkheads to
match the top contour.
Using a utility knife and 60 grit paper, cut and sand
a taper on the front of the deck joiner.
It should go from nothing at the front, to full
thickness about 4 inches from the front.
Take your time, and make a smooth progression.
Use your plane to shave the top stringers (and
sides) to the contour of the bulkheads.
Do this the same way you did the bottom.
Use 80 grit to finish it up. Be sure not to round the
edges.
Glue the deck supports into bulkheads 4 and 5.
Use a straight edge between the bulkheads to
check the deck supports.
Summary of Contents for I-BOX
Page 8: ...I B O X N B O X 6...
