R I V E T T / R O C K E T T
7
Marking parts before removal.
Bulkhead 3 with turn fin doubler in place.
Doubler installation. Note bottom chine slot is
not covered.
Let’s get started
The first thing you should do is to
carefully sand the parts while they are
still in the sheets. Do this with your 80
grit sanding block.
Sand both sides, as this will make it
much easier to sand the parts once they
are out of the sheet.
While the parts are still in their sheets,
use a pencil to mark each part with the
name. Note that the parts only fit
correctly one way.
Turn fin doubler
Sand the edges of bulkhead 3. Sand
inside the holes.
Remove the cutout containing the turn
fin doubler.
Remove and sand the doubler. Toss the
piece it was in.
The doubler only goes on correctly one
way.
Hold the doubler over the matching
holes on bulkhead 3. Make sure you are
on the FRONT RIGHT of the bulkhead.
This will be the forward facing side.
Summary of Contents for Bullitt Thunderboat
Page 55: ...R I V E T T R O C K E T T 53 ...
