R I V E T T / R O C K E T T
25
Rear sanded for non trips.
Forward end of rear non trip sanded and
ready.
Rear non trip in place.
The rear non trip sides are designed to
go outside of the hull, over the sides and
bottom.
The sides must be sanded flat in order
for the sides to fit.
Use your plane and 80 grit to make the
sides and bottom flat.
Test fit the non trip in place.
When satisfied with the fit, glue in place
with thin CA and accelerator. Glue
again.
Repeat on other side.
When cured, sand the rear non trips and
deck supports flush with the back of
bulkhead 6.
Summary of Contents for Bullitt Thunderboat
Page 55: ...R I V E T T R O C K E T T 53 ...
