R I V E T T / R O C K E T T
11
Bulkhead 6 being glued in place with gusset
installed.
Inner chine in place.
Inner and outer chines in place.
Clamp a piece of wood to the rear of
bulkhead 6 to keep it straight if needed,
and then glue it and the gusset to the
bottom
with
epoxy.
Be sure the back of the bulkhead is flush
with the back edge of the bottom.
Chines
Gather the inner chines and sand the
edges smooth.
The chine for the right side has two holes
in it.
Slip the inner chines in place from the
bottom. Check to see that the bottom is
flush with the bulkheads.
Install the outer chines, be sure they are
flush with the bottom of the bulkheads
and.
Wick thin CA in the joints and hit with
accelerator.
Summary of Contents for Bullitt Thunderboat
Page 55: ...R I V E T T R O C K E T T 53 ...
