Page 4 of 16
Zip Hydro Tap Installation and Operating Instructions - 81759 - February 2013 v2.01
These installation instructions cover the range of chilled only and C125+ model
HydroTaps.
When correctly installed, operated and maintained in accordance with these
instructions, the Zip chilled only and C125+ HydroTaps are intended to deliver
filtered chilled water for consumption.
Models covered by these instructions
Installation requirements
Before installing ensure that the following have been provided at the
installation site:
• Sufficient space in the cupboard to install the undersink unit in accordance
with these Installation Instructions. A table of dimensions is given below.
NOTE: Add 65mm to the Width of the undersink unit to allow for Water and
Electrical connections.
• A water supply connection with isolating valve inside the cupboard
within reach of the 750 mm flexible connection and positioned so that
the connection point and the stop cock will not be obstructed when the
undersink unit is installed.
• Power supply 220-240 Volt AC, for connection to the heater via a 10 amp
G.P.O.
Frost Protection
If this appliance is located where the ambient air temperature could fall below
5ºC when the heater is not in use, do not turn off the appliance electrically.
This safeguard does not offer the same protection to the connecting pipework
and fittings.
Installation Environment Considerations
This unit is intended for indoor use only and should never be installed outdoors
or exposed to the elements of nature. This unit must not be positioned in an
area that may be cleaned by a water jet. This unit must not be cleaned by a
water jet.
# Section
Heading
# Section
Heading
Read these warnings
continued
Height
mm (inch)
Depth
mm (inch)
Weight empty
kg’s lbs
Weight full
kg’s lbs
340 (13.4)
455 (18)
305 (12)
32 (70.5)
35.8 (79)
Width
mm (inch)
Model
C125+ Chiller
C
Model
125+
Glasses of Chilled
Water per Hour
