INSTRUCTION MANUAL
Semi-automatic BOV Filling Machine Z-2323
A0310.02.2323.905.1.EN
Page 36/39
Replacing the closing Teflon cone of filling head
1.
Close the inlet of the product to the cylinder by tightening the knurled screw [Fig. 9, pos. 1]
of the product cylinder non-return valve after loosening the securing nut [Fig. 9, pos. 2].
2.
Disable product supply to the machine. It involves switching off any installed product
pumps and emptying whole installation supplying product to the machine.
3.
Place empty aerosol container with crimped valve under the filling head. Using footswitch
START perform single filling cycle on empty container.
4.
Disable compressed air supply. It involves closing the main cut-off valve and emptying
whole pneumatic installation supplying the machine.
5.
Block the filling head connector using 22 mm flat wrench and unscrew the filling head using
17 mm flat wrench (insert wrench between spring coils) - Fig. 24, pos. 1.
6.
Pull gently up and remove the spring, spring mounting washer and covering sleeve - Fig. 24,
pos. 2.
7.
With the use of a 5 mm hex key, unscrew the spring fixing nut [Fig. 24, pos. 3].
8.
Remove the nut, spring and replace the Teflon cone in the filling head - Fig. 24, pos. 4.
9.
After replacing the cone, assemble the filling head parts in the opposite order.
Summary of Contents for Z-2323
Page 42: ...PNEUMATIC DIAGRAMS ...
