15
Sy
st
em
C
ont
rol
RS-232 commands:
Zigen RX AV baud rate
Change baud rate for RXAV. Coming soon in future RXAV revisions. Disclaimer: RXAV with current
firmware baud rates need to be changed on the rxav web interface.
RS-232 commands can take ASCII, HEX, or a mixture of ASCII and HEX.
To send an ASCII command, make sure the dropdown is in ASCII or MIX modes.
ASCII command formatting:
To send an ASCII command, make sure the command is surrounded by quotes.
Example: “@rxav rel1 on\n”
Note: special characters such as ‘\n’, ‘\r’, and ‘\t’ will be interpreted as ONE character, not two.
HEX command formatting:
To send a HEX command, make sure the dropdown is in HEX or MIX modes.
HEX command formatting:
To send a hex command, the formatting is as follows:
0xZZ,
where ‘Z’ is a character from 0-9, A-F, a-f. NOTE: hex commands need to start with
0x.
MIX allows a mixture of ASCII and HEX commands to be sent over RS232.
If there are multiple commands, use a comma to separate each command.
We can delay a command by using the Delay keyword.
The formatting is as follows:
Delay-
xxxx, where “xxxx” is the delay in milliseconds.
Commands not specified will be ignored.
ZigNet: Control Page (continued)