G07 User Manual
3
2 Installing Mounting for G07
Requirements:
Mounting fixtures
Drill with 5mm (0.2 inches) drill bit size (if using wall plugs) or 3.5mm (0.14 inches) drill bit size
(if not using wall plugs)
Size 1 Phillips screwdriver
a)
Locate G07 with at least 15cm (approx.. 6 inches) spacing on each side (except on mounting side)
avoiding the following sources of interference: direct sunlight, air flow from vents, fans, doors,
windows, heaters, sources of steam, oil vapor, etc.
b)
If necessary, pre-drill mounting holes using mounting cradle for alignment, then use appropriate
drill bit to drill the holes – 5mm (approx. 0.2 inches) if using wall plugs or 3.5mm (approx. 0.14
inches) if not using wall plugs.
c)
If necessary, use a hammer to insert wall plugs into the 4 holes.
d)
Use size 1 Phillips screwdriver to fasten the screws securing the mounting cradle. Note: pay
careful attention to the orientation of the mounting cradle.
e)
Install and remove G07 using the following actions to ensure the mounting cradle has been
correctly and securely installed and G07 can be installed and removed.
Install -
Remove -
Initial hardware installation for G07 has been successfully completed.
