ZIGBEE G07, User Manual

Page: 15 / 17

G07 User Manual
15
8 Joining Other Devices to G07’s IoT Network
Requirements:

Child device, such as repeater (eg. WZB-01USBR, WZB-02485R), or end device (eg. STH-01
series, STH-03ZB, S05 series)

Sharp pointed tool (if needed)
a) Ensure G07 is powered on (see “ Powering On G07 ”) and ready to receive data from the Child
Device.
b) Ensure child device(s) to be joined to G07’s IoT network is/are in Ready to Join status (see relevant
device’s manual).
c) Apply 1 quick press to the Join button on G07, the green LED will flash once every 3 seconds for up
to 60 seconds to indicate the Permit Join status, allowing other devices to join to its IoT (Internet
of Things) network.
d) Check the status of the device to confirm it has been connected (see relevant device’s manual).
e) Repeat the above steps until all devices have been added successfully.
9 Removing Devices from G07’s IoT Network
Requirements:

Child device, such as repeater (eg. WZB-01USBR, WZB-02485R), or end device (eg. STH-01
series, STH-03ZB, S05 series)

Sharp pointed tool (if needed)
a) Ensure G07 is powered on (see “ Powering On G07 ”).
b) Ensure the devices are powered on (see relevant devices’ manual) and is connected to G07 or its
repeaters.
c) Reset the child device (see relevant device’s manual; for Nietzsche IoT child devices, the reset
operation is to press and hold the S1 link switch for 3-5 seconds).
d) Check the status of the device to confirm it has been removed (see relevant device’s manual).
e) G07’s Wireless LED should return to light off.