☞
6. Timer operation
The timer allows you to switch on the heater automati-
cally at a preset time.
In order to switch on the timer, the correct time must
have been set and the heater should be off. Follow the
procedure below:
[1] Press the TIMER button. The TIMER light and the
information display will start blinking.
[2] Use the adjustment buttons to set the time at which
the heater must ignite. Use the button on the left
(
c
hour) to set the hours and the button on the right
(
d
min.) to set the minutes (interval of 10 minutes).
[3] Press the ON/OFF button while the information dis-
play is blinking.
[4] After approximately 10 seconds the information dis-
play will show CLOCK again and the TIMER indicator
light will light up, indicating that the timer function
has been activated.
To clear the timer setting, press the ON/OFF button once.
Note: When the room temperature is less than
15°C, the preset time is changed automatically
depending on the room temperature in order
to heat the room by the desired time.
Room temperature
Ignition time
More than 15°C
Set time
0°C ~ 15°C
10 minutes before set time
Less than 0°C
20 minutes before set time
7. Room temperature sensor
The room temperature sensor is fitted with a 2.5 meter
cable. This is located on the back of the heater. Ensure
that the cable does not touch the outlet tube. The
room temperature sensor can be installed with cello
tape or with a wood screw.
Select the location where the sensor is to be installed in
such a way that it will not be exposed to direct sun-
light, draughts or the warm air flowing out of the
heater.
8. Childproof lock
The childproof lock can be used to prevent children
accidentally changing the heater settings. When the
heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are
blocked then. If the heater has already been switched
off, the childproof lock also prevents accidental ignition
of the heater. Activate the childproof lock by pressing
the appropriate button and holding it down for more
than 3 seconds. The KEY-LOCK indicator light will light
up, indicating that the childproof lock has been activat-
ed. Switch off the childproof lock by pressing the but-
ton and holding it down for more than 3 seconds once
again.
9. Switching off the heater
There are two ways to switch off the heater.
[1] Press the ON/OFF button. The information display
will show the CLOCK signal. The air circulation venti-
lator and the ventilator motor continue to operate
for approximately 3 minutes in order to cool the
heater down.
[2] Press the TIMER button, when you want to switch
off the heater and ignite it again with the timer the
next time. This not only switches off the heater, but
it also activates the timer function. You can change
the required time with the adjustment buttons.
10. Recovery after overheating
The heater is protected against damage caused by
overheating.
A sensor will activate if the temperature in the
housing exceeds 80°C.
Step 1: Switch the heater OFF.
Step 2: Allow the heater to cool down.
Ensure that the metal housing has cooled sufficiently
before touching it.
Under normal conditions, a period of 30 to 45 minutes
is sufficient to allow the heater to cool down
completely.
Step 3: Pull the heater plug out of the socket.
42
Chapter 2, OPERATION