ZF Marine ClearCommand, Manual, Page: 95 / 104

TROUBLESHOOTING
Page 9
AT THE
N
EUTRAL
/I
DLE POSITION REGARDLESS OF THE
C
ONTROL
H
EAD LEVER POSITION
.
Cause :
The Processor is in the Set-up Mode and an adjustment setting is
selected.
Remedy :
Configure the Processor into the Run State by placing Jumper 2 in the
Open State and SW1-1 through SW1-7 to the Off positions. Refer
to the Run State Section of the manual.
1.17SYMPTOM - S
ET
-
UP
M
ODE IS ENTERED AND THE NORMAL
3
SECOND
STEADY TONE IS HEARD
. T
HE MOTOR CONTROL RELAY
“
CLICKS
”
CONTINUOUSLY WHEN THE
D
IP
S
WITCHES ARE TURNED
O
N
.
Cause :
An invalid switch combination is selected.
Remedy :
Turn SW1-1 through SW1-7 to the Off positions. Refer to the Notes
page of the System Drawing in Appendix C for proper switch settings.
1.18SYMPTOM - T
HE MOTOR RELAY DOES NOT CLICK ONCE
,
INDICATING
VALUES HAVE BEEN STORED
,
WHEN
PB1
ON THE
A
UXILIARY
C
IRCUIT
IS DEPRESSED
.
Cause :
Each Step in the Set-up & Adjustment Sections of the Technical Man-
ual were not followed exactly.
Remedy :
Repeat the set-up or adjustment following each step exactly.