Travel speed calibration
FHD14N072
Dashboard is calibrated after assembly at a production plant.
Do repeated calibration in the following cases:
- after a significant wear of tyres
- when mounting new tyres
- when replacing dashboard
Calibration procedure
- at a suitable place, mark a track of 100 m at length
- inflate tyres of tractor on the prescribed pressure, see tables of this Instructions manual
- start the engine
- move the tractor to the beginning of the 100-metre track
- enter the service menu by pressing
(A)
button
- select the item (
1
) by (
B
) and (
C
) buttons and by pressing (
A
) button go to calibration menu
- select the item (
2
) by (
B
) and (
C
) buttons and move to the speed menu by pressing (
A
) button
- select an item (
4
) by (
B
) and (
C
) buttons and by pressing the (
A
) button, move to the following menu. The
item (
3
) serves only for setting the travelling speed in the production plant
- select an item (
5
) by (
B
) and (
C
) buttons and confirm with the (
A
) button
- start the tractor with a stable speed of approximately 10 km/h
- after travelling the whole distance of 100 m stop the tractor at the marked end of the track (
b
)
- select the item (
6
) by pressing the buttons (
B
) and (
C
) and by pressing (
A
) button, save the newly read
values and you will return to initial screen
- if calibration of travelling speed did not run properly, error report will appear on the display (
7
), after
confirming the item (
8
) you will return to initial screen by pressing the (
A
) button without saving the new
values
DASHBOARD
58
Summary of Contents for CRYSTAL Series
