Zetor CRYSTAL Series, Operator'S Manual

Page: 150 / 182

Replacing full-continuous motor oil filter
C15N079
1 - Cover
2 - Sealing ring
3 - Jacket
4 - Guide
5 - Filter element
6 - Clamp
Procedure for filter element replacement
Release the cover (1) by 2 to 3 revolutions and wait ca. 30 seconds.
Unscrew the cover (1) in anticlockwise direction.
Carefully release the filter body from the guide (4) in the jacket (5) in the upward direction.Catch the leaking
oil in a suitable vessel.
Slightly bend the filter element (5) in the retaining vessel to the side until the element is released from the
clamp (6).
Clean the components.
Replace the sealing ring (2) and oil it slightly.
Press the new filter element (5) into the clamp (6) and carefully put them together in the guide (4).
Firmly screw the cover (1) (25 Nm) in clockwise direction.
Check the tightness when the engine is running.
Fuel Filtering
The full flow oil filter is located in the right side of the
engine and is accessible when the engine bonnet is open
and the right bonnet sidewall is disassembled. The
replacement of the filter element is performed after each
oil change in the engine.
The replacement is performed when the engine is not
running.
C15N080
The fuel filters are located on the right side of the engine.
The fuel filtration is two stage:
preliminary fuel filter with desilter (1)
fine fuel filter (2)
C15N081
MAINTENANCE INSTRUCTIONS
149