Smart Connect Multi-loop Installation Manual
www.zetaalarmsystems.com
39
Panel Printer
(SMART Connect Multi-loop systems with a fitted panel printer only)
Loading/Replacing the Printer Paper Roll
The SMART Connect Multi-loop uses a CUSTOM PLUS2 RS232 panel printer. This printer will accept printer rolls that meet the following
requirements:
Specification
PLUS2
Paper Type
Thermal Paper Roll
Paper Width
57mm
Roll Diameter
50mm
Roll Length
30m
(See note)
Paper Weight
55 to 70gsm
To change the printer roll, proceed as follows. Every time the paper is changed, check inside the device to locate and remove any
Scrap pieces of paper.
1.
Open the printer cover.
2.
Place the roll in the paper compartment and pull out a few
centimetres of paper.
3.
Close the printer cover.
4.
Remove any excess paper.
Note:
Paper roll length is approximate, based upon readily available UK sourced paper
with 12.7mm core.
