Zero Motorcycles S 2021, Owner'S Manual

Page: 38 / 160

Controls and Components
3.18
A.
Headlight High/Low Beam Switch
When the switch is pushed, the headlight
changes from low beam to high beam. It stays
in the selected position until it is switched
back. When in high beam position, the high beam indicator
on the lower dash illuminates.
B.
Flash-to-Pass
When the headlight is in the low beam position, push the
flash-to-pass switch and the high beam illuminates and
stays illuminated until the switch is released. When
released, this switch defaults back to the low beam position.
The high beam indicator also illuminates.
C.
Front Brake Lever Adjuster
Adjustment knob to set front brake lever position. Refer to
“Parking Brake Operation (if equipped)”, on page 3.21 .
D.
Front Brake Lever
The front brake lever controls the front brake when the lever
is squeezed. When braking, the throttle should be in the
closed position. The brake light also illuminates.
E.
Throttle Control
Twist the throttle in a counter-clockwise rotation (A) to
energize the motor and start the motorcycle in a forward
direction. Release the throttle and it snaps back to the
closed position (B), de-energizing the motor, and
regenerative braking begins.
When the motorcycle is moving and the throttle control is in
the fully closed position, the regenerative braking feature
activates. Regenerative braking takes some of the energy
from the moving motorcycle and turns it back into electrical
energy. This energy is then stored in the power pack,
contributing to increased energy efficiency. A slight drag is
felt when the regenerative braking is activated. If you want
to coast without the regenerative braking, hold the throttle
just off of the fully closed position.
Zero Owner's Manual (S and DS).book Page 18 Monday, September 21, 2020 11:43 AM