ZN 2500-130/150
32
Installation
www.zepro.com
Image 50. Fit end stops between the lift arms
and the rear beam of the vehicle floor
4.5
Armstops
Fit end stops between the lift arms and the rear
member of the vehicle floor. The left and right end
stops must be reached at the same time, as high up
the lift arm as possible. Installation must take place
against the vehicle body.
m
WARNING!
It is not permitted to perform welding in the lift arm.
Installation must take place against the vehicle body.
Image 51. Installing a sealing strip
4.6
Sealing strip (horizontal)
The track is fitted using the self-tapping screws pro
-
vided.
1. Mark where to drill holes for the self-tapping
screws.
2. Drill holes (Ø 7.2 mm) for the screws.
3. Fit the horizontal stop strip (steel or aluminium).
4. Fit the rubber strip to the track.
4.7
Sealing strip (vertical)
1. Fit the tracks with contersunk screws, rivets or by
spot welding.
2. Fit the rubber strip to the track.
3. Secure the rubber strips by swaging the tracks
together at the bottom.
NOTE!
To fit an upper edge seal, create a 45° mitre against
the vertical strips.
Summary of Contents for ZN 2500-130
Page 2: ......
