ZN 2500-130/150
Before installation
19
www.zepro.com
3.9
Prepare the tail lift
1. Position the support frame under the vehicle’s chassis.
2. Remove the protective cover mounted using to quick release locks; see Image 18.
3. Fold out the control card / relay card (B) and loosen the cabling at the connector on the hydraulic unit; see
Image 19 and Image 20.
4. Release the hydraulic unit by unscrewing the wing nut and corresponding screw (C); see Image 21 and
pull out the hydraulic unit until the tank cap is accessible; see Image 22.
m
CAUTION!
Make sure no cables are pinched or in any other way damaged when the control card / relay card is folded out or removed.
Do not pull out the hydraulic unit more than necessary; make sure it is not pulled completely out of the frame, as this can
entail a risk of injury and damage to the equipment.
5.
Check whether the hydraulic tank is fitted with a transport plug seal. If so, replace it with the regular tank
Image 18.
Remove the protective cap
C
A
B
Image 19.
Release mechanism
Image 20. Connection socket
Image 21.
Releasing the hydraulic unit
Summary of Contents for ZN 2500-130
Page 2: ......
