30
2
3
5
4
8. Installation, continued
Ring
Screw
Adjustable collar
Lock screw
NOTE!
To have the taillift to comply with CE requirements
and be safe, it is required that tilt down angle is adjusted to
a maximum of 10º.
NOTE!
It is necessary to first adjustment the 90º tilt angle
up against the body before adjusting tilt down angle.
1. Run the lift up so that the lift is at the floor level, see pict
22.
2. Loosen the ring's lock screw (2). Screw the ring out in
the direction of the platform (3). See pict 23.
3. Tilt down the platform to maximum 10 degrees under
horizontal. As per pict 22.
4. Adjust the ring to the top of the cylinder (4).
5. Tighten the lock screw in the ring (5). See pict 24.
Reassemble rubber bellows, see pict. 21
Lock screws torque is between 3-5 Nm.
Note! Both cylinders tilt down angle must be adjusted
equally, otherwise there is the risk that the cylinders will
break. Test run all functions.
Adjustment of tilt down angle.
Pict. 20
Pict. 21
Pict. 22
Washer
