27
Max 40 mm, Min 38 mm
A
A (mm)
81
8. Installation, continued
When the platform is installed you should test run
the lift carefully. Check the platform position at rear
beam. Adjust the position of the lift if necessary.
See
picture 11.
The platform´s overlap (A) is dependent on the type
of platform. Please note the values below which are
particulary relevant when installing a rubber seal on
the body at the top of the platform.
Steel
Pict. 12
Pict. 11
Pict. 10
Type
Installation of platform
Install platform onto the lift arms and tilt cylinders to the platform. Use axles and support wheels provided.
Axles is locked with eye bolt incl. screw M12x25 (80Nm), bag 380 and 381.
NOTE!
O-rings must be installed
at the same time as axles. 2 pcs Ø56 on lift arm-platform and 2 pcs. Ø 50 on tiltcylinder-platform, on each side.
(
See pict. 10)
