NETWORK CONNECTION
The M2-MVB on board web page can be approached via ethernet or via Wifi.
You can choose one of the 3 following option to connect and setup your Zepcam MVB
Option 1
Connect over a network using DHCP
●
Connect M2-MVB to the same network as you PC is connected to.
●
Use the PC-tool “Zepcam Finder” to discover the IP address of your M2-MVB.
(Contact your zepcam contact person to get Zepcam Finder)
●
On your PC enter the IP address in your web browser to access the onboard webpage.
Option 2
Connect Ethernet service port with Fallback IP
●
Connect an Ethernet cable between your PC/laptop and the M2-MVB ethernet service
port
●
Set the network settings for your PC to :
-
IP adres computer
: 10.150.161.2
-
Subnet Mask
: 255.255.255.0
●
On your PC enter 10.150.161.1 in your web browser to access the onboard webpage.
Option 3
Via Wifi (Your PC/laptop must connect directly to the MVB network)
●
Make sure the Wifi antenna is connected to the M2-MVB (see figure 1.2)
●
By Default the wifi-accesspoint mode in the M2-MVB is enabled. When the
wifiaccesspoint mode is disabled you can press the maintenance button 5 seconds
(Beep) - The M2-MVB creates its own WiFi network with its serial number a SSID.
●
On your computer select the Wifi network to connect to the M2-MVB
●
On your computer open a browser (Chrome recommended) and enter
http://10.150.160.1
●
Push Maintenance button again to leave maintenance (+Wifi) mode
More information and FAQ on:
www.zepcam.com/support
11
Summary of Contents for Mobile Video Box M2
Page 1: ......
