ZEOS PANTERA, User Manual

Page: 35 / 77

35
Fixed Disk 0 Type
Sets the hard drive 0 configuration. This option was set to Auto
at the ZEOS factory prior to shipment. In most cases, this
option is all you need. When Auto is selected, the system
determines what kind of hard drive is installed and displays the
drive parameters.
Note: Only change this option setting if you change your hard drive.
Multi-Sector Transfer
Determines the number of sectors per block for multiple sector
transfers. Options are Disabled, 2, 4, 8, and 16. The default is
16. Older hard drives (and even some newer drives) will not
work properly if the number of sectors is set too high.
LBA Mode Control
Enables or disables Logical Block Addressing, allowing you to
use large IDE hard drives. This must be enabled for IDE hard
drives greater than 528 MB.
Physical Drive
Determines the physical address of the drive. Options are :
Default, Primary Master, Primary Slave, Secondary Master, and
Secondary Slave. The default is Default.
Fixed Disk 1 - 3 Control
If your system has more hard drives installed, again set these
options to
Auto . This sets the drive type for the additional hard
drives. Never needlessly change the default setting.
Chapter 3 - Using SETUP