Z41 Remote
http://www.zennio.com
Tecnical Support:
http://zennioenglish.zendesk.com
12
show the indicator – the list may be updated at any time by pressing on the icon,
in the upper right corner of the screen). A few seconds later, a virtualisation of the
Menu page of the remote Z41 will be represented on the mobile device (Figure 12),
which will look analogous to the real Z41 interface the on-site user interacts with.
From this point, the application behaves as the actual Z41, so the user can get rid of
learning about a new interface. In addition, any action implying changes on a control or
an indicator will be notified to the real device, which will reflect equivalent changes on
the screen and will also send the KNX bus the corresponding objects, when required.
Note that certain functions implemented by Z41 are
not controllable
from the remote
application (in such case, icons and indicators show faded colours):
Within the Profile page
: configuring the contrast, the brightness and the
audible signals is not possible remotely, although the profile selection is.
Within the Configuration page
: the programming LED, device reset and
device pairing controls are not available remotely, while the time set, the
alarm log and the probe calibration do offer remote interaction (assuming they
have been enabled in ETS).
Once the user interaction with the remote device is over, the user should finish the
session by pressing on the
Close
button, available on the upper right corner of the
application. Closing the session takes the user back to the main window (Figure 3).
Note
:
if a new communication session with the same remote device is started before
30 seconds after ending the previous session, the user will recover the control as it was
before the interruption. However, more than 30 seconds after the interruption, new
sessions will always begin from the Menu page of Z41
.
Important
:
in case the application is ordered to run in background, all remote sessions
currently active will be interrupted
.
USER PROFILES
Note
:
this function is supposed to be used only upon Zennio’s request
.
Z41 Remote allows switching to certain user profiles depending on the context where
the application is going to be used. The different profiles do not entail differences in the
functionality nor implications for the user, but they ensure that the data of users of a
