Touch-MyDesign
Technical Support:
http://zennioenglish.zendesk.com
38
Sending of “0”, DELAY
: defines a delay (in tenths of a second) to be applied
prior to sending the value “0”. The time count starts when the actual rising/falling
edge that originates the sending takes place.
Sending of “1”, DELAY
: defines a delay (in tenths of a second) to be applied
prior to sending the value “1”. The time count starts when the actual rising/falling
edge that originates the sending takes place.
Periodical sending of “0
”: defines a cycle time, in seconds, for cyclically re-
sending the value “0”. If this parameter is set to “0”, no cyclical re-sending will take
place for “0”.
Periodical sending of “1
”: defines a cycle time, in seconds, for cyclically re-
sending the value “1”. If this parameter is set to “0”, no cyclical re-sending will take
place for “1”.
Lock
: selecting “Yes” will display a new 1-bit communication object, “[Ix] Lock”,
that permits locking or unlocking the corresponding input (by sending the values “1”
or “0”, respectively). While the input remains locked, any order it sends will be
ignored.
Sending of status (0 and 1) on bus voltage recovery
: when this option is
enabled, the device will perform an automatic sending of the status of the input line
through the “[Ix] Edge: binary control” object whenever a bus power recovery
happens. A certain delay (0-255 seconds) will apply if a value different to “0” is set
for the “Sending delay” parameter.
3.5.3
TEMPERATURE PROBE
Configuring an input as a temperature probe will bring up the objects “[Ix]
Current temperature” (2 bytes) and “[Ix] Probe error” (1 bit) to the Topology window in
ETS. The first one reflects the current value of the temperature measured by the probe
connected to the input clamp of Touch-MyDesign. The second object, for its part, will
inform about whether there is an error in the connection of the probe (if so, the value of
the object will be “1”) that is preventing the reception of the measured values.
Moreover, when an input has been configured as a temperature probe, it will be
possible to set a few more parameters from the window that is displayed for that
purpose.
