ZENN
iO
AVANCE Y TECNOLOGÍA
www.zennio.com
41
BOX 1 (Programming button):
When programming a device physical
address, users can set the “Programming Mode” directly from this box. This
characteristic makes this process easier as the user won’t need to access
the rear side of the panel to push the “Programming Button” any more.
BOX 2 (Time setting):
This box allows setting the time in the Touch
Panel. It must be taken into account the next characteristics:
Time (together with the room temperature) is always displayed in
the middle upper section of the display.
When setting the time, the display will send the new settings to the
bus through its own Communication Objects.
The refresh rate is 1 minute.
When the display recovers from a bus Power failure, this will show
the time it had just before the incident.
Note I:
When a Power bus failure occurs, please have on mind the delay this
implies to correct it.
Note II:
There are different KNX devices on the market which can
synchronize periodically the time and date of every single device in the
installation. Such devices can be really useful when the installation is based
on any kind of Schedule programming.
BOX 3 (Date setting):
This box allows setting the date in the Touch
Panel.
To see the date in the display, users only have to press on any of the
enabled pages “header”. The date will be shown during 3 seconds.
Note: The day of the week does not appear on the display; however, when
programming the display, this is automatically configured when setting the
date.
BOX 4 (Display Contrast setting):
The contrast of the panel can be
adjusted from this box. The range for this function lied between 0 and 20.
Default value is
12
.