Flat Sensato
Technical Support:
8
2.2
TEMPERATURE
Flat Sensato is capable of measure and monitor temperature measurements, as well
as send
these values to the bus
and
report high / low temperature situations
. To
that end, it is necessary to configure a set of parameters.
ETS PARAMETERISATION
The object “
[Temp] Current Temperature
” (2 bytes) will appear by default. This object
will report the current value of the temperature periodically or after a certain
increment/decrement, according to the parameter configuration.
Figure 5.
Temperature - Configuration
Temperature Sensor Calibration
: defines an offset to be applied to the
measurement received from the probe to correct deviations due to external
factors. The offset should be in the range [-50, 50] tenths of a degree.
Temperature Sending Period
: sets every how much time the value of the
current temperature should be sent to the bus (through “
[Temp] Current
Temperature
”), in the range 0 – 255 tens of second. The value “0” leaves this
periodical sending disabled.
Send with a Temperature Change
: defines a threshold (in the range 0 to
255 tenths of a degree) so that whenever a new reading of the current
temperature is found to differ (from the last value sent to the bus) more than
such threshold, an extra sending will take place.
The value “0” leaves this
sending with a temperature change disabled.
