AudioInRoom
Technical Support:
15
Regardless of the devices connected via Bluetooth, AudioInRoom can
configure the following controls:
➢
Initial Volume:
volume that will be set on each channel and/or subchannel
after programming or a power loss. It is also the initial volume when the
sound is played from the auxiliary input.
➢
Volume Limitation:
maximum value for the output volume of each
amplifier. The real output volume will be the result of adjusting the volume
established by the user [0-100%] to the configured limit value, as follows:
[Limit] = 50%, [Control Volume] = 50%
[Output Volume] = 25%
[Limit] = 60%, [Control Volume] = 60%
[Output Volume] = 36%
[Limit] = 60%, [Control Volume] = 50%
[Output Volume] = 30%
However, this limitation is transparent to the user. In other words, the value
of the volume control object is shown on the bus in any case.
Mute audio output:
it is possible to mute the output volume in each channel
and/or subchannel by communication object.
Tone:
AudioInRoom has, in addition to
Ring Tone
, a
Welcome
and
Wake
Up Tone
. These
three ringtones emit a beep through the speakers that will
sound even when the Bluetooth module is off.
Mute tones:
AudioInRoom can control whether or not the Ring Tone and the
Welcome Tone sounds depending on the state of the room.
Alarms:
AudioInRoom provides three high temperature warning alarms, one
for each channel and one for the device itself.
When an alarm occurs, audio playback is stopped. To deactivate the alarm, it
is necessary to correct the problem that generates it (probably a connection
error) and unfreeze it. The object for unfreezing the alarms is common to all
of them.
For serial numbers prior to 20ACC0494 the welcome and wake up tones are
not supported.
