802149NZ - BHA; CHA; CSHA -Installation Instructions - Aug 2015 - V2.00
Page 9 of 28
Technical Specifications
Residential Models:
BHA
= Filtered Boiling water with unfiltered Hot and Cold Ambient water
CHA
= Filtered Chilled water with unfiltered Hot and Cold Ambient water
CSHA = Filtered Chilled and Sparkling water with unfiltered Hot and Cold Ambient water
Note
:
chilled water will continue to be dispensed after the rated capacity has been used, although this
may be at slightly higher temperature.
Product covered by these instructions:
** Add an extra 4 kg
when full of water
GPO's
Required
Power
Rating
(kW)
Unit Dimensions
W x D x H
(mm)
**Dry
Weight
(Kg)
Chilled Sparkling
BHA
1x10A
1.425
280 x 313 x 335
8
CHA
1x10A
0.125
280 x 392 x 335
20
CSHA
1x10A
0.3
280 x 392 x 335
23
Before installing ensure that the following have been
provided at the Installation site:
•
Review all the technical specifications.
•
Ensure the underbench can support the product weight when full of water.
•
Sufficient space in the cupboard to install all of the undersink units in
accordance with these Installation Instructions. Refer to technical specification
for dimensions. Refer to section 3 & 4, for Installation instructions.
•
For Zenith Celsius models, a 220-240Vac, 10A GPO will be required.
NOTE: Check all cable and hose lengths against inlet /outlet
positions before proceeding
(See section 4 for general layout).
•
A potable water supply connection with isolating valve inside the cupboard
within reach of the braided hoses and positioned so that the connection
point and the stop cock will not be obstructed when the undersink units are
installed.
•
If an external filtration or water softening device is required, then it is
important to allow extra space for these items.
•
A cold water supply with a minimum working pressure of 172kPa for BHA &
CHA or 250kPa for CSHA units and a maximum working pressure of 700kPa
connected via an isolation valve.
•
The appliance must be placed with it’s base in a horizontal position.
IMPORTANT!
Do not proceed with the Installation if these requirements are
not met.
