Page 6 of 24
803341NZ - HydroTap Taps Install Instructions 09.18 v2.11
1.2
BENCH TOP
Ø35mm
Single
Bowl
35mm
HOLE
Apply a light smear of silicon sealant on the underside
of the black plastic spacer, to ensure a watertight seal.
Fit the spacer and pass all the hoses, tubes and USB
cable through the 35mm hole. Position the tap so that
it discharges into the sink.
From under the sink/bench, fit the stainless steel
washer and spider clamp to the all-thread rod, and
secure with the nut. The washer is formed similarly
to a spring washer. It will flatten once the assembly is
tightened.
Note
:
feed each of the three tubes and USB cable
evenly in between the legs of the spider clamp.
Note
:
If the flow rate is too fast, insert the
Teflon restrictor into the silicon Hot Outlet tube
6mm NUT
SPIDER CLAMP
STAINLESS
STEEL WASHER
1 - HydroTap Classic & Elite
HydroTap Classic
Elite
1.1
Position the tap such that it dispenses into the sink
bowl with ample clearance for a cup or tea pot.
Alternatively, the tap could be mounted away from the
sink using a font, available as an accessory.
Cut a 35mm hole in the bench / sink top.
BLACK
PLASTIC
SPACER
A
M6 ALL-THREAD
ROD
TEFLON FLOW
RESTRICTOR