Zenith H2546DT, Installation And Operating Manual, Warranty

Page: 10 / 48

P A G E 1 0
206-3492-O
Hook Up Cable Service (CATV) and VCR
Connect a VCR and Cable service to the Presentation TV.
Leave the VCR and the television tuned to channel
three and use the cable box to change channels.
No A/V cables are included with your Presentation
TV. Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
Cable TV
wall jack
RF coaxial wire (75 ohm)
Cable box
In
Out
In
Out
Audio Video
3 4
VCR back
VCR back AV panel
output
switch
3 4
output
switch
RF coaxial
wire (75 ohm)
not included
with TV
A/V cables
not included
with TV
VIDEO
ANTENNA
CABLE
R- AUDIO- L S-VIDEO IN
COMPUTER
AUDIO
R
L
AUX IN
M.P.I.
TV back
R- AUDIO- L
R- AUDIO- L
S-VIDEO OUT
COMPUTER
IN
AUDIO OUT
Cable TV
wall jack
Round wire (75 ohm)
In
Out
Audio
Video
3 4
VCR back
VCR back AV panel
output
switch
RF coaxial wire
(75 ohm)
not included
with TV
A/V cables
not included
with TV
VIDEO
ANTENNA
CABLE
R- AUDIO- L S-VIDEO IN
COMPUTER
AUDIO
R
L
AUX IN
M.P.I.
TV back
R- AUDIO- L
R- AUDIO- L
S-VIDEO OUT
COMPUTER
IN
AUDIO OUT
Locate the Antenna/Cable jack on the back of the
VCR.
Connect the cable that runs from the wall directly
to this jack, according to the diagram to the
right.
Remove the back of the remote and put in two
AAA batteries.
Plug in the TV. Do not plug it into a switched
outlet. The Presentation TV is designed to oper-
ate on standard current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC Current.
Go to page 16 to Auto Program the Presentation
TV.
1
2
3
4
5
back of
remote