Page 20
19. The spar boxes made of 2mm fit and glue the balsa. Between rib # 1 and # 6 is the spar boxed
on both sides, from rib # 6 only one-sided on the trailing edge side. Danger! The waste that is
made up the balsa board with the spar castings milled parts results, becomes later yet for the
round boxing required!
20. Opening for insertion into the spar casting drill. As drill becomes the aluminum insertion sleeve
used. To becomes one pipe end jagged. Then the pipe is through the millings in the ribs inserted
and the pipe in a drill clamped. It must care must be taken that the pipe not bruised becomes.
Then it is done without much pressure drilled through the caste system. Link to video on
vimeo:
Page 21
21. The plug-in sleeve is fitted with a balsa piece on one side locked to prevent slipping to prevent
the insertion rod. There should be a little hole for it pressure equalization in the closure be
made.
22. The plug-in sleeve is on both sides boxed upright with 2mm balsa.
23. Now the tasting is flush with the Holm and ground to the profile contour.
24. Pull in the servo cable. On easy, cables adapted to the power requirement respect, think highly
of.
Page 22
25. Prepare the lower cladding. It have to deal with parts again will.
Page 23
26. Then the lower planking similar to the one above upset will. It comes with the front planking
started, then the rear glued and final the Intermediate pieces fitted. During the drying time
should the wing half well on the sliding weighted or fastened so that there are no delays sneak
in.
27. After the bond has dried can the wing half of the taken slipway and sanded down. For the
leading edge contour balsa stencils are included. For greater stability, the use the templates
carefully beforehand low viscosity superglue to be soaked.
28. Then the rudder flap split off. The rudder caste is from the border of the 2 mm balsabrettes
created in which the milled parts for the spar casings found to have. The afford cut to length,
stick together and then sand down.
Page 24
