20
MAS7.1 Component Video Switch
21
MAS7.1 Component Video Switch
1 2 3 S1 S2 S3 SYNC
Step 1: Set the MAS7.1 to the preferred initial power on state
Setup the MAS7.1 to the initial
power on state you’d prefer. In
this case we want the MAS7.1
to turn on and switch to Input
when first plugged in.
Step 2: Save the new initial power on state
1 2 3 S1 S2 S3 SYNC
Start by pressing and
holding the Power
button...
Setting the Initial Power On State
As long as the MAS7.1 is plugged in, it will remember the previously
selected input in standby mode. When powered up by pressing the
Power button, it will return to that previously selected channel.
However, if power is removed (for instance a plug strip used to
power the MAS7.1 is turned off ), and then re -applied, the MAS7.1’s
default behavior is to enter into the standby mode.
I t is possible to change the initial power on behavior of the MAS7.1.
To change the initial power on defaults...
Step 1: Setup the MAS7.1 to your preferred power on state
.
Use the front panel buttons to setup the MAS7.1 to the op -
erating settings you’d like at initial power up.
Step 2: Save the new initial power on state.
First press and hold the Power button.
While continuing to hold the Power button, press and hold
the ‘1’ button.
After holding both buttons for about ‘’ seconds, the dis-
play will blink indicating the new power on defaults have
been accepted.
Test the new initial power on state
You can test the new defaults by either disconnecting the
power supply from the back of the MAS7.1 or by unplug-
ging the power supply from the wall.
Reconnect power. The MAS7.1 will power up into your new
power on default state.
•
1.
2.
3.
•
•
1
2
...while continuing to hold the Power
button, press and hold the ‘1’ button.
After about seconds, the display will
flash indicating the new Power On
Default state has been accepted.
3
