12
HDVI5 Component Video Switch
1
HDVI5 Component Video Switch
1 2 3 4 5 SEL A1 A2
Step 4: Select between Bright and Dim settings: Use SEL button.
Step 5: Adjust Front Intensities.
1 2 3 4 5 SEL A1 A2
Use A1 and A2 to dim and brighten LEDs
A1 = Dim LEDs.
A2 = Brighten LEDs.
Adjusting the Front Panel Intensity
Continued from previous page...
If you have not already done so, per form Steps 1 and 2 on the previ-
ous page.
Step 4: Toggle between Bright and Dim Settings
The 'SEL' LED indicates the front panel intensity settings:
If BLUE LED is lit, then the BRIGHT level is being adjusted.
If RED LED is lit, then the DIM level is being adjusted.
Use the 'SEL' button to toggle between bright and dim
settings.
Step 5: Adjust Front Panel Intensities
Use the ‘A1’ button to decrease the intensity of the front
panel lights.
Use the ‘A2’ button to increase the intensity of the front
panel lights.
You cannot make the DIM level brighter than the BRIGHT
level, and you cannot make the BRIGHT level dimmer than
the DIM level.
Step 6: Use the Power Button to Exit
Once the front panel intensities are acceptable, press the
Power button to save the new settings and exit the setup
mode.
Note:
The new intensity settings are saved in non-volatile
memor y and are not affec ted by a power failure.
•
•
•
•
•
•
Use the SEL button to toggle between
the BRIGHT and DIM settings.
1 2 3 4 5 SEL A1 A2
Step 6: Use the Power Button to Exit.
When things look good, press the
power button to exit setup mode.
All manuals and user guides at all-guides.com
