HDVI5 Component Video Switch
5
HDVI5 Component Video Switch
Initial Setup...
Use the analog input connec tions to switch component
video / composite video / analog audio or any combination
of the above signals to the HDVI5’s analog output connec-
tors. Use the digital audio connec tors to switch digital au-
dio signals, with automatic conversion between the optical
and coax digital audio formats.
If using a hardwired IR controller to operate the HDVI5,
connec t the controller IR cable to the IR / Z-IN jack .
If using a PC (or other serial controller), connec t it to the
RS-22 por t using a standard serial cable.
Plug the power module into the HDVI5, and plug the mod-
ule into a standard A.C. wall receptacle. The standby LED
will light up.
Selecting an Input...
To switch between any of the five inputs, simply press the
button for the desired input. If the HDVI5 is in the standby,
it will turn on. The HDVI5 will then switch to the selec ted
input, and the associated LED will light to indicate this.
To place the HDVI5 back into the standby mode, press and
release the Power Toggle button. The channel LEDs will all
go blank , and the standby LED will light up. Press the Power
Toggle button again to re -selec t the previously selec ted
input.
Audio / Video Breakaway...
To break away the audio or video (to listen to the audio
from one input while view the video from another), press
the SEL key. When both the RED and BLUE LEDs above the
SEL button are lit, then the audio and video inputs will be
switched simultaneously. When only the RED LED is lit, then
only the Audio will be switch. Similarly, when only the BLUE
LED is lit, only the video will be switched when pressing an
input button.
Note:
Audio breakaway only applies to the digital audio con-
nec tions on the back of the HDVI5. You cannot break-
away the HDMI audio channel that is sent over the HDMI
cable. HDMI audio will always follow the video signal.
•
•
•
•
•
•
•
Step 1: Make the appropriate connections.
(Picture of back of HDVI5)
Selecting an Input: Press numbered buttons to select an input.
1 2 3 4 5 SEL A1 A2
Easy, Simple, Instructions!
1 2 3 4 5 SEL A1 A2
Audio / Video Breakaway: Press SEL to toggle breakaway options.
Only red LED, above
the SEL button is lit,
so only Audio is
switched when
'' is pressed.
All manuals and user guides at all-guides.com
