MODIFYING THE LAMP MODULE
Colibri.2
Inserting or changing LED modules
Carl Zeiss
07/2014
423052-7244-001
25
5.2
Inserting or changing LED modules
To make them distinguishable, the LED modules are provided with adhesive labels where
wavelength and part number are indicated. The mounts for the LED modules are marked with
the position numbers
to
, corresponding to the numbers (1 to 4) on the control panel. If
all LED modules are to be mounted, they should be inserted according to increasing wave
lengths, beginning with position
.
According to how the LEDs are combined, many different configurations are possible. Some
configuration proposals are given in the overview of chapter 7.
•
Insert the LED module (Fig. 5-3/
1
) into the mount up to the stop position (here, for example, the
mount for channel
).
•
Tighten the knurled screw (Fig. 5-3/
2
) slightly to hold the module in place.
•
Connect the cable of the LED module (Fig. 5-3/
3
) to the corresponding socket. With the LED module
inserted, the cable length allows only one plug-in position.
•
Proceed in reverse order to dismount it: Press the clip of the plug and remove the cable from the
socket. Loosen the knurled screw and pull the LED module out of the mount by pulling on the knurled
screw.
•
Do not pull the connection cable to remove the LED module.
•
No adjustment is required after changing LED modules or beam combiners.
The bandwidth of an LED module can be restricted by using an excitation filter (diameter
25 mm). The filter has to be fixed by a retaining ring.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
