EN
25
7. Guide the sensor cable, together with the wire ends, from the inside to the outside through the cable guide of the
EPP housing, and push the sensor cable into the cable recess.
8. Connect the sensor cable to the clamping point SENSOR X8 on the control board.
Watch out for the correct assignment of the wires in accordance with the assignment of the SENSOR
X8 terminal!
Colour coding for sensor cable
SENSOR X8 clamping point
Signal
brown 1
+
white 2
-
green 3
CL
yellow 4
DA
9. The four-pin DIP switch MODE SW1 is used for the configuration of the Automatic function for the respective
sensor module. If necessary, correct the positions of the DIP switches in accordance with designated functional
principle of the Automatic mode.
Fig. Position of DIP switch, factory setting
10. Carefully install the sensor cable at the edge of the control board, and clamp the PVC cover back into the guide
slots on the EPP housing.
11. Install all parts in reverse order.
Summary of Contents for ComfoSpot 50
Page 34: ...EN 34 Terminal scheme...
Page 39: ...EN 39 Product data sheet...
