2
- programming while machine running - you can immediately see effects
- each curve can be set in 4 to 12 curve points
- 3D interpolated ignition map, if TPS selected
- signal delay compensation
- instant monitoring of revs and angle, via LCD(hand held programmer)
- programmable power valve actuation
- store and load function for 5 PV curves
- external switch for changing PV curve while riding
- programmable PV deviation
- programmable max close and max open positions
- self PV test on power-up
- PV error detecting (position sensor failure, servo motor failure)
- fast processing for high accuracy - delays from 1us
- timing calculation for every 1 RPM change (1000, 1002, .. , 9805, 9806, ...)
Very important!
Resistor spark plugs must be used, because they produce less electromagnetic disturbances.
Very important!
PDCI is protected against static discharge, but too high static charge can damage PDCI.
Be careful when using programmer on the dyno, because static charge can build up on the bike and
static discharge can damage PDCI unit, or programmer. Make ground connection between dyno and
bike frame to prevent static discharge.
Danger of electric shock!
Avoid connecting PDCI to 12 V power supply before connecting to ignition coil. High voltage is
generated and touching free wires can cause electric shock, or damage the unit.
1.
HOW TO ENTER MENU
PDCI
does not need to be connected to power supply when battery is installed in to the handheld
programmer. Connect
programmer
to
PDCI
and wait few seconds for activation of
programmer
and then press ENTER . Move through menu with pressing + , or - and choose with pressing
ENTER .
Exit menu with choosing
Exit.
2.
MENU ORGANISATION
Set Ign.
- set ignition parameters submenu
Set PV
- set PV parameters submenu
Exit
