Regency Owner’s Manual
Page 16
4.0.3.6 Spa Mode
The next available setting will be the Spa Mode. There are two Spa Modes: Auto,
Manual.
Auto mode:
Will allow the Spa controller will execute all the default function as
programmed at the factory
(RECOMENDED MODE).
Manual Mode:
Let the user set all the spa parameters as follows.
The first parameter is the filter cycles, this screen will allow the user to set the number of filter
cycles during an 24 hours period, the maximum number of cycles is 4 and could be set by
depressing the Programming key and then either the Up or Down keys until the desire setting is
obtained then saved by depressing the Programming key one more time:
Next screen is the cool down cycle; the maximum setting is 180 seconds. It is defined as the
number of seconds the pump will run after the heater is turned off:
Next screen is the clear cycle; the maximum setting is 180 seconds. It is defined as the number
of minutes the air blower will run to clear some stagnated water in its pipes:
Next screen is the Post filtration cycle, the maximum setting is 180 minutes the minimum 30
minutes. It is defined as the number of minutes after the user exit the Spa.
Manual Mode
Filter Cycle <# of cycles>
Manual Mode
Cool Down Cycle < #Seconds>
Manual Mode
Clear Cycle <# minutes>
Manual Mode
Post Fil <Ending Time>
