Regency Owner’s Manual
Page 10
Note
If the Spa is equipped with a circulating pump only, it will be
used for filtration and heating instead of the low speed pump.
3.0.1.2 Water Pump 2 Key
Will control a secondary pump On/OFF.
3.0.1.3 Blower 1 Key
Will activate the primary air blower (bubbler). It is an ON/OFF key
3.0.1.4 Blower 2 Key
Will activate the secondary air blower (bubbler). It is an ON/OFF key
3.0.1.5 Done Key
This key should be depressed after the Spa had been used. A depression of this key will
signal to the microcontroller in the system that Spa’s software management should take
over and execute the filtration cycles, heat maintenance, etc.
3.0.1.6 Light Key
Will activate the lights used in the Spa. It is an ON/OFF key
3.0.1.7 Auxiliary Key
Will activate any device attached to the Auxiliary relay in the system board. It is an
ON/OFF key
3.0.2 Status Control Keys
There are 3 status control key: UP, Down and Programming. Their function will be
explained during the Spa Programming section of this manual.
