Advanced Handheld CCD/Laser Scanner
2
P
ROGRAMMING
G
UIDE
Introduction to Scanner Configuration
Scanning a series of programming barcode labels can configure the series scanners.
This allows decoding options and interface protocols to be tailored to a specific
application. The configuration is stored in non-volatile memory and will not be lost by
removing power from the scanner.
The scanner must be properly powered before programming. For RS-232C type
scanners, an external power adapter must be used to supply DC power to the scanner.
If a keyboard emulation type scanner is used with an IBM PC/XT/ AT, PS/2 or any fully
compatible computers, power will be drawn from the keyboard port. No external
power adapter is required. If keyboard emulation type scanner is used with any other
non IBM PC compatible computers, an external power adapter may be needed.
During the programming mode, the laser scanner will acknowledge a good and valid
reading with a short beep. It will give long beeps or remain silent for either an invalid
or bad reading.
Programmable options are divided into four groups. The first group includes the
options that show the general behavior of the laser scanner. The second group
governs the operation of different interfaces, RS-232 serial ports, keyboard, and USB.
The third group sets the decoding parameters for each barcode symbology. The last
group is about more advanced data formatting.
Summary of Contents for z-3101
Page 1: ...GLLS...
Page 2: ......
