After unpacking the
, check whether deliverables are intact and complete. If any
damage is found or any component is missed, contact the dealer.
Check the list in the table 3-1.
inverter
Installation
3
3.1 Installation Process
3.1 Installation Process
Figure3-1 Installation flowchart
Start
Outlines of this chapter
This topic describes how to install the 20~33KTL-G2.
Installation notes
Caution
Danger
Attention
Do not install the inverter on flammable building materials.
Do not store the inverter in areas with flammable or explosive materials.
Do not install the inverter in places prone to body contact because the inverter
shelf and heat sinks become hot during the inverter operation.
Take the inverter weight into consideration when transporting and moving
the inverter.
Install the inverter in an appropriate position and surface.
Assign at least two persons to install the inverter.
This topic describes the process for installing the 20~33KTL-G2.
3.2 Checking Before Installation
Before unpacking, check that the packing materials are intact. After unpacking, check that the
deliverables are complete and intact.
3.3 Tools
Prepare tools required for installation and electrical connections.
3.4 Determining the Installation Position
Determine an appropriate position for installing inverter.
3.5 Moving the inverter
This topic describes how to move inverter to the installation position horizontally.
3.6 Installing the inverter
Before installing inverter, secure the shipped rear panel to the wall. Then secure inverter to
the rear panel by using hexagon screws.
Check before
installation
Prepare installation
tools
Determine the
installation position
Moving the
inverter
Installation the rear
panel
Installation the
inverter
End
3.2 Checking Before Installation
Checking Outer Packing Materials
Checking Deliverables
Packing materials and components may be damaged during transportation. Therefore, check
the outer packing materials before installing the inverter. Checking the surface of packing
materials for damage, such as holes and cracks. If any damage is found, do not unpack the
inverter and contact the dealer as soon as possible. You are advised to remove the packing
materials within 24 hours before installing the inverter.
15
16
20~33KTL-G2
User manual
20~33KTL-G2
User manual
