Zcom WS10G2, User Manual

Page: 18 / 78

Hyperion Series Wireless LAN Controller User Manual
58-150008-IQN_V1.0 Page 15
Parameter Description
backup purpose.
Subnet Mask Allocate a netmask for the ‘AP Access Port’ to divide which subnet the WLAN port is
belonged to.
Designate AP Service Port The AP service port in the WLC is used for user client traffic, which is different from the
AP access port used for AP management. However, this port can be located on the
same physical port as the thin AP access port (TAP), and distinguished by VLAN ID; or
it can be located on other VLAN interfaces (VIF1~VIF8). The default value is the TAP
port.
Click the Apply button to accept the changes.
Click the Cancel button to discard the changes.
Note: If these parameters modified, it is necessary to Save Configuration and then reboot system to make
them to take effect.
4.3. M
ANAGEMENT
P
ORT
The first 1000Base-T RJ45 port (that is, the GE1 port) must be the management port of the WLC. Customers mainly use
the management port to manage, maintain and configure WLC. The default IP address of the management port is
192.168.2.228 .
Select
[Network > Management Port] in the menu to enter the configuration page as following:
Figure 4-3 Management Port Configuration Page
These parameters in
[Network > Management Port] page is described in details as following:
Parameter Description
VLAN ID If the external switching device or host connected to WLC is configured with a VLAN,
this port must be assigned a VLAN ID for WLC management and maintenance.
IPv6 Address It is necessary to allocate an IPv6 address to the ‘Management Port’ if the WLC is
deployed in an IPv6 network.