SP230/SP230-S5
2x2 PtP/PtMP 802.11ac Wave 2 Outdoor Access Point
User Manual
Page 10
2.
Protect components from electrostatic discharge: Please wear an ESD wrist strap or handle the
power adapter by its edge and do not touch any component or printed circuit boards,
especially for module device.
3.
Make sure to keep the temperature and humidity of the installation location at an optimal
level.
4.
An excellent grounding system guarantees the stable operation of device, as well as to protect
device from lightning, interference and electrostatic discharges.
5.
If installed outdoors, the device may be damaged by lightning. We recommend that you install
additional lightning protection devices if necessary, considering the conditions in your area.
6.
Supply stable power to the device. Unstable power may cause the device to malfunction. The
device supports PoE power supply and is recommended if the device is installed near grid lines
within less than 100 meters radius.
Installing a Waterproof Cable Gland for Ethernet
3.6.
Port (Optional accessory_
SP-WP-CM20)
Dismantle all the components of waterproof cable gland, and plug the cable
through it. Thread and assemble one by one: sealing nut, plastic ring, rubber,
finally is locking nut. Securely tighten all the components.
Powering the Access Point
3.7.
Connect the PoE cable into the WAN/PoE IN port of the device, then it will power on.
Warning:
Do
NOT
attempt to connect any
non-PoE
devices to LAN port and make sure
the input power should comply with PoE Out standard.
Note:
Please wait for 5-10 seconds while powering on.
Note:
For PoE Out applications, the LAN port provides DC 48V, Max. 208mA, and up to
10W power supply. The positive side of the 48V is connected to pin 4 and 5, the negative
side is connected to pin 7 and 8.
