This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated
WEE/CG0783SS collection point as defined by your local council.
© 2022 System Q Ltd
2
Contactless Exit Buttons
Zap is a registered trademark of System Q Ltd
Document ref: qACC351-362
All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is
made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise,
from errors or omissions in these instructions, or the performance or non-performance of the equipment refered to.
Sensitivity & Time Delay Adjustment
Troubleshooting
If the exit button is not activating the lock then there is likely a shorted wire, open circuit or some
other failed device in the circuit.
To identify where the fault is, each wired connection in the circuit needs to be tested; working from
the push button progress through, including the keypad, the access controller, power supply and the
magnetic lock.
If the fault is with the access control button then check the connection wires for continuity and for
trapped wires. Check for water ingress on the wired connections. Check the polarity in the power
connections and ensure the connections are connected to the proper terminals.
Specification
ACC351
ACC352
ACC361
ACC362
Construction
Stainless Steel
Stainless Steel & Plastic
Plastic
Alloy
Detection
Range
50 – 200mm
80 – 420 mm
90 - 300mm
80 - 200mm
IP-Rating
IP68
Internal Use
IP68
Latch
1-30 secs
Mimic
1-30 secs
1-25 secs
LED Colour
Idle-Blue/ Active-Green
Idle-Blue/ Active-
Green
Idle-Red/ Active-Green
Idle-Blue/ Active-
Green
Rating
2A @12V DC
3A @ 12V DC
2A @ 24V DC
Terminals
NO/ NC/ Common/ 12-24V DC/ GND (Wires)
Voltage
12-24V DC
Dimensions
86 x 86 x 20mm
86 x 86 x 37mm
86 x 86 x 20
80 x 32 x 23mm
