Problem
Possible cause
Remedy
There is no spark when light-
ing the gas
Burner cap and crown are
placed uneven
Make sure that the burner cap and crown
are in correct positions.
The flame is blow out immedi-
ately after ignition
Thermocouple is not heated
sufficient
After lightning the flame, keep the knob
pushed for approximately 5 seconds.
The gas ring burns unevenly
Burner crown is blocked with
food residues
Make sure that the injector is not blocked
and the burner crown is clear of food parti-
cles.
The appliance does not oper-
ate
The fuse in the fuse box is
released
Control the fuse. If the fuse is released more
than one time, refer to a qualified electrician.
The oven does not heat up
The oven is not switched on
Switch on the oven.
The oven does not heat up
The necessary settings are
not set
Control the settings.
The oven lamp does not op-
erate
The oven lamp is defective
Replace the oven lamp.
Steam and condensation set-
tle on the food and in the
oven cavity
You left the dish in the oven
for too long
Do not leave the dishes in the oven for lon-
ger than 15 - 20 minutes after the cooking
process ends.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC)
.........................................
Serial number (S.N.)
.........................................
Installation
Warning!
Refer to the Safety chapters.
Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
14
www.zanussi.com
