9
E
N
G
L
IS
H
Insert the hose provided in the kit into the detergent
container.
2. Dishwashers
with
incorporated
peristaltic
rinse-aid dispenser pump (Figure 13).
Pump “S” dispenses about 0.1 g/s of rinse-aid. It
dispenses 0.3 g in 3 sec. at each rinse.
Dispenser operating time may be changed, following
the instructions given in the next paragraph.
Insert the hose provided in the kit into the rinse-aid
container (in the versions without incorporated rinse-
aid dispenser only).
3. Dishwashers
with
incorporated
rinse-aid
diaphragm dispenser pump (Figure 13).
Pump “T” is installed in appliances with pressure boi-
ler.
Dispensed amounts may be changed according to the
instructions given in the paragraph below.
Insert the supplied hose into the rinse-aid container (in
the versions without incorporated rinse-aid dispenser
only).
Connections for automatic detergent dispenser
(Figure 13)
Figure 13
There is a ready-made impression “N” to be perforated
(Ø 8 mm) for positioning the detergent concentration
measuring sensor.
In the front area of the tank there is a hole “P” (Ø 10 mm)
closed with a plug that is designed for fitting a liquid
detergent injector.
The sensor and liquid detergent injector should be
installed without prejudicing the watertightness of the
appliance.
Electrical connections for automatic detergent and
rinse-aid dispensers.
Single-phase version:
The appliance has a terminal board for the power sup-
ply of dispensers operating at 230 V, max. power
30VA.
Connect to the terminal board “L” (Figure 13) to termi-
nals 1 and 2 for dispensing during the rinse cycle or to
terminals 3 and 4 for dispensing during the wash cycle.
Three-phase versions:
Terminals are available on the power supply terminal
board for the electrical connection of external dispen-
sers working at 220…240 V. Max. power 30 VA.
Figure 14
•
Connect the
detergent dispenser
between termi-
nals 7 and 9. These connection points are live
during filling of the tank for 165” (average filling
time at 200 kp) and during the rinse cycle.
Figure 15
•
Connect the
rinse-aid dispenser
between termi-
nals 8 and 9. These connection points are live
during the rinse cycle.
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air.
Simultaneously press the buttons, as shown in the
figures below. If necessary, repeat this operation
several times.
N
P
T
D
L
S
R
DETERGENT DISPENSER
DISPENSER RINSE-AID
L1
L2
L3
1
2
1
2
Summary of Contents for NUC
Page 2: ......
