ZANTIA 0601-0169, Use And Maintenance Manual

Page: 49 / 88

49 Mod. CRONOS rev 01
Alarms
translated from the original text
EN
6.4 EXTINCTION DURING OPERATION
ALARM
If the fire goes out during operation and the flue gas tempera-
ture drops below the minimum operating threshold, this
alarm is triggered immediately.
fig. 40 control panel - extinction during operation alarm
The switch-off procedure is immediately activat-
ed.
6.5 AUGER SAFETY PRESSURE SWITCH
ALARM
If the pressure switch (negative pressure meter) detects pres-
sure lower than the triggering threshold, it triggers by cutting
power to the auger and simultaneously displaying the mes-
sage “ALB NO NEGATIVE PRESSURE”, stopping the system.
fig. 41 control panel - auger safety pressure switch alarm
6.6 GENERAL THERMOSTAT ALARM
If the general safety thermostat detects a temperature higher
than the triggering threshold, it is triggered by cutting power
to the auger and simultaneously displaying the message “AL7
THERMAL PROTECTION”, stopping the system.
fig. 42 control panel - general thermostat alarm
6.7 FAULTY FLUE GAS EXTRACTION FAN
ALARM
If the flue gas extraction fan is faulty, the product stops and
displays the message “AL4 EXTRACTOR FAULT”.
The switch-off procedure is immediately activat-
ed.
fig. 43 control panel - flue gas extraction fan alarm


6.8 INSUFFICIENT DRAUGHT ALARM
Should the message “AL9 INSUFFICIENT
DRAUGHT” appear, contact Technical Assistance
Service.
fig. 44 control panel - insufficient draught
6.9 TRIAC ERROR ALARM
Should the message “ALB TRIAC ERROR” appear,
contact Technical Assistance Service.
fig. 45 control panel - triac error
6.10 WATER PRESSURE ALARM
Should the message “ALE WATER PRESSURE” ap-
pear, contact Technical Assistance Service.
fig. 46 control panel - water pressure